1. Every shift must be lubricated once before each shift is turned on. (manipulator, manipulator guide, open die guide rail. 

2, swing arm can (3-4) day add once, the big chain of heating machine, small chain can once a month. Check whether the main reducer and the heating machine are short of oil. Main engine bearing can be added up to 3 months. 

3. Check whether the moving parts are strong before production, and whether the screws are loose and loose, especially if the driving part of the strong impact force is abnormal. 

4. Check the high pressure gas source, low pressure air source, power supply and water supply. 

5. Check the emergency stop switch, safety door switch and protection device to check whether the switch is normal. 

6. Check the heating head into the embryo. 

7. Check the lamp tube for damage and breakage. Change it in time. 

8. Check whether the pneumatic components are leaking and are sensitive. 

9. Check whether the triple valve body is abnormal, whether it is blocked, and whether the water cup is too full. 

10. When there is any abnormality in the mechanical and magnetic valve of the blowing bottle, clean the > in time. 

11. The blowing mould must be cleaned regularly and cleaned regularly. 

12. When opening the high and low pressure gas source switch, slow motion must be made to prevent the gas flow from moving too fast and the dirt into the solenoid valve. Meanwhile, open the exhaust valve for 30 seconds to make sure the air is clean. 

13. Machine starting must be sure that the mechanical part is good, no foreign matter. In particular, the position of sports, in order to avoid hurting people. Simultaneously close the security door. 

14. When starting the machine, the heating machine must be started to prevent voltage fluctuation. Determine whether the cooling water is unopened before starting the heating. 

15. After the heating starts (2-3) minutes, the temperature of the oven will rise even, then the next bottle embryo. 

16. During the operation of the machine, when the bottle-blower puts the blank and the bottle, pay attention to safety. It is strictly forbidden to reach into the mold. 

When there is an emergency, you can press the emergency stop button and the emergency brake. Then based on the analysis of the situation, the problem is solved quickly. 

18. The machine must pay close attention to whether the machine has abnormal noise, and it should be found early, and the machine will be shut down early. 

19. After normal operation of the machine, do not put any part of the body into the machine to prevent the mechanical arm from hurting. If the machine has a different sound, it must slow down and observe. 

20. After the normal production of the machine, the operator must constantly observe the quality of the bottle, so as to avoid the fluctuation of the voltage or other reasons to influence the quality of the bottle. 

21. When the machine is repaired, the repair button can be used on the touch screen to ensure the safety and maintenance. If you need to manually observe the action of each cavity, please pay attention to the position of the manipulator. At the same time, be sure to understand the role of the individual button and then move to make sure that the wrong action causes unnecessary trouble. 

22. After each maintenance of the machine, it is necessary to clean the tools and screws and so on, so as not to leave them in the machine and affect the normal operation of the machine and avoid accidents.